User Manual

MOUNTING INSTRUCTIONS

MOUNTING SWIVEL BRACKET

1) Secure the Swivel Ball to the base of the controller

using the #10-32 screw.

2) Attach the swivel ball to the swivel bracket base using

the provided screw.

3) Using the provided screw, secure the two clamps

loosely together.

4) Place the clamps and screw around the 2 swivel balls.

Tighten the clamp screw, thereby attaching the swivel

bracket base to the full function controller.

5) Secure the Swivel Bracket to the rear of the controller

(as shown in the diagram).

6) Place the unit against the intended mounting surface.

7) Mark the areas where the mounting holes will be drilled.

If the mounting surface is part of the vehicle, make sure

no vital components could be damaged by the drilling

process.

8) Drill two mounting holes on the mounting surface,

making sure no vital components of the surface are

damaged.

9) Using customer provided screws, secure the Full

Function controller to the mounting surface.

#8-32

MOUNTING L-BRACKET

1) Utilizing the provided screws, secure the L-Brackets

to each sides of the controller using a Phillips head

screwdriver at a torque setting of 1 in*lb.

2) Place the unit against the intended mounting surface

and mark the areas where the mounting holes will be

drilled. If the mounting surface is part of the vehicle, make

sure no vital components could be damaged by the drilling

process.

FENIEX // 2019 // INSTRUCTION MANUAL // v2.2

WEB // www.feniexindustries.com