Specifications

Battery Replacement
1. Rotate the tail cap button according to the direction of the "OPEN" logo, and pull out of the
battery case.
2. Insert the battery according to the polarity markings of the battery compartment.
3. Insert the battery case into the light body, and after the battery case is flush with the light
body, rotate the tail cap button in the opposite direction of the "OPEN" logo.
Mounting Instruction
Bicycle light and wireless switch
1. Loosen the screw of the bike mount. Fix the bike mount in the desired position on the bike
handlebar and fasten the screw.
2. Loosen the fine adjustment screw of the handlebar mount before clamping the mount to the
bar by securely tightening the set screw. Slide the light into the mount until a distinct “click” is
heard.
3. Fasten the cable of the wireless switch to the desired position on the bike handlebar.
Note:
1. Adjust the direction of the light before testing the power and functions of the bicycle light.
2. Use the shims provided according to the diameter of the bicycle’s handlebars:
a. Thick + thin shims together: diameter 22-28mm;
b. Thin only: diameter 28-32mm);
c. No shim (whenever applicable): diameter 32-35mm.
3. The bicycle light can be used on a helmet with the Fenix bicycle light helmet holder.
Low-voltage Warning
The functional switch will flash red to remind to replace the batteries when the voltage level
drops below a preset level. The bicycle light is programmed to step down a few lumens to
prolong the runtime and the light will not turn off automatically.
Note: This may not work if 4*CR123A batteries are being used.
Overheat Protection
The light will accumulate a lot of heat when working on High mode for extended periods. When
the light reaches a temperature of 65°C, the light will automatically step down a few lumens to
reduce the temperature. High mode can be reselected if needed.
Usage and Maintenance
 Disassembling the sealed head can cause damage to the light and will void the warranty.
 Replace the battery in time to ensure normal use for next time.
 If the light will not be used for an extended period, remove the battery, or the light could be
damaged by electrolyte leakage or battery explosion.