User Manual

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are

present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if

any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing

materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original

factory box and packing.

If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The

arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.

POWERSUPPLY

On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains

voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also

be directly connected to the mains and may be used. No dimmer or adjustable power supply.

Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate

electrical ground to avoid the risk of electrocution or fire.

OPERATION

1. Switch the function mode to PH. Turn on the power switch at the rear of the turntable player. The PH indicator will light

up.

2. Place a record on the turntable platter and select the desired speed (33/45/78RPM) according to the record.

NOTE: when playing a 45RPM record, use the included 45RPM adapter located inside the

accessories bag.

3. Remove the stylus protector. Open the tone-arm clip to release the tone-arm. Push the lift lever

backward to raise the tone-arm and gently move the tone-arm to the desired position over the

record. The turntable will begin to spin when the arm is moved toward the record. Push the lift

lever forward to lower the tone-arm slowly onto the desired position on the record to begin playing

the record.

Remark:- This switch turns auto stop on or off. When the automatic stop is enabled, the platform will start rotating as

soon as the tone arm is placed over the record and will stop rotating when it has reached the end of the record. Some

vinyl records stop before the end or do not stop when the end is reached. In this case set Auto-stop to OFF.

4. Turn the Volume Control Knob to adjust the volume.

5. Turn the Pitch Control Knob to fine tune the speed

AUX

1. Press mode button till the BT indicator lights up, this is AUX IN mode also.

2. Connect your audio device, MP3 player, mobile phones etc. to the AUX IN port with a 3.5mm jack audio cable (not

included). You can enjoy the music from the speaker of turntable player immediately.

3. Turn the volume control knob to adjust the volume.

1. Switch the function mode to BT. The LED indicator will become blue colour with flashing.

2. Turn on the BT function of your mobile phone, tablet or other BT device and search the turntable player with its name

Fenton recordplayer.

3. After pairing and connection, the LED indicator will become blue colour without flashing and you can play your music

from your BT-device.

4. Turn the volume control knob to adjust the volume.

Remark: During the BT mode, please make sure that the AUX IN jack is not plugged.

RECORD

Plug in the USB drive, press mode key to select phono, press and hold the button until the USB/REC indicator flashes and

the recording from vinyl records to USB starts. Press and hold the

button to stop the recording.