User Manual

3
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
FRONT PANEL
1. POWER SWITCH: Turn the device ON or OFF.
2. HEADPHONES JACK: 3.5mm input jack for connecting headphones.
3. HEADPHONE OUTPUT SWITCH: Put this button in the pressed position to pass the signal to the connected headphone.
Put the button in the protracted position to pass the signal to the speaker outputs.
4. MP3 CONTROLS: Press this button to start/resume or pause play. Turn left to select the previous track, turn right to select
the next track.
5. TREBLE CONTROL: Adjust the high frequencies of the corresponding channel.
6. BASS CONTROL: Adjust the low frequencies of the corresponding channel.
7. VU-METER: Displays the level of output.
8. INPUT SELECTOR: There are 3 different input positions: CD, BT/USB and DVD. In BT/USB mode: the unit will
automatically go in USB mode when a USB stick is inserted. When no USB stick is inserted (or when withdrawing the USB
stick from the device) the unit will scan for BT devices automatically.
9. MASTER VOL: This knob controls the master volume.
10. USB PORT: You can play media files from a USB stick by inserting the USB stick in this slot.
11. BT LED LIGHT: When BT mode is enabled, this light will flash. Make sure that no USB stick is inserted.