User manual

EN
2 Ferm
PAINT SPRAY GUN
Read the safety and operating
instructions of the air tool and the
compressor before using the appliance.
Contents
1. Machine data
2. Safety instructions
3. Use
4. Maintenance
1. Machine data
Technical specifications
Operating pressure 4.5 - 6 bar
Nozzle diameter 1.5 mm
Maximum nozzle flow rate 6.5 cfm
Container capacity 400 cc
Weight 0.50 kg
2. Safety instructions
Explanation of symbols
In this manual and/or on the machine the following
symbols are used:
Wear protective gloves
Use a spray-mask during spraying
Wear eye protection
Safety instructions
• Avoidtoohighpressure
• Neverbloworsprayindirectionofyourselfor
others; this could cause serious injury.
• Keepbystandersandpetsaway
• Childrenandanimalsshouldbekeptfaraway
from the area of operation of the machine.
• Ifyouusethecompressortospraypaint:
a) Do not work in enclosed spaces or near
naked flames.
b) Make sure that the environment in which
you will be working has dedicated
ventilation.
c) Protect your nose and mouth with a
dedicated mask
• Ifthecompressorisnolongerinuse,always
take the plug out of the plug socket.
• Alwaysmakesurethatcompressed-airhoses
are used for compressed air and which are
characterised by a maximum pressure
adjusted to that of the compressor. Do not try
to repair the hose if it is damaged.
3. Use
Only use the compressor with accessory in a good
ventilated area.
• ConnectthePUhosebetweencompressor
and accessory
• Slidethehose-couplerontheaccessoryuntil
the coupler clicks. Now the hose is connected
correctly.
• Toreleasethecoupler,pulltheoutsidering
backwards.
Use paint spray gun
Paintandsolventsareveryflammable.Therefore
check the following:
• Onlysprayingoodventilatedareas
• Useaspray-maskduringspraying
• Avoidopenfireandsmokingduringspraying
• Donotsprayinanareawithaburningstove
• Neverspraywithfuelofotherflammable
products
• Wearsafetygoggles
Toobtainthebestresults,itisimportantthatyou
prepare the surface to be sprayed and thin the
painttothecorrectviscosity,beforeyouoperate
yourspraygun.Alwaysensurethatthesurfacesto
besprayedarefreefromdust,dirtandgrease.
Make sure that you have masked the areas that
shouldnotbesprayed,usingagoodquality
maskingtape.Thepaintorfluidtobesprayed
should be thoroughly mixed and free from lumps
or other particles. Many substances can be
sprayedwithyourspraygun,butalwayscheckthe
manufacturers recommendations before
purchasing your paint.
Toobtainthebestresults,keepyourspraygun
level and parallel to the surface at all times.
Keepthenozzle25-30cmfromthesurfaceand
spray evenly from side to side or up and down. Do
not spray at an angle as this will lead to paint runs
on the surface. Use smooth and even strokes.
It is essential that the spray gun is cleaned
thoroughly after every use. Failure to clean it will
almost certainly result in blockages and it may not