Operation Manual

OPERATION
SELECTING THE GRINDING STONE
In general, coarse grinding stones are used to remove
material and fine grinding stones to finish the workpiece.
If the surface is uneven, start with the coarse grinding
stone until the surface is smooth. Then use the fine grin-
ding stone to remove any scratches caused by the coarse
grinding stone to finish the workpiece.
GRINDING
The grinding machine comes with one grinding disc for
dry grinding and one for wet grinding. In principle, the
dry-grinding disc is suited for corase grinding and the
wet-grinding disc for fine grinding where it suffices to
press the workpiece lightly against the grinding stone.
This grinding machine has been especially designed for
treating and grinding tools with cutting edges such as kni-
ves, scissors, chisels, etc. For best results, fill the water
container with tap water.
Do not “fill up” the stone by holding wood, lead or any
other soft metal against the grinding stone. Never press
the workpiece too hard against the stone, to avoid
making grooves. Cool down the workpiece with water.
Wood chisels and such must never “blue” when being
ground. Make sure the workpiece cannot slip from your
fingers during grinding and get caught between the tool
rest and the stone. This may cause the stone to crack,
the motor to stall and the workpiece to rebound, cau-
sing injuries.
OPERATION
- Make sure the switch is in the “OFF” or “0” position
before you plug in the machine.
- Move the switch to the “ON” or “1” position to start
the bench grinder.
- Keep the cable away from moving parts.
TROUBLESHOOTING
In case the grinding machine does not work well, we give
you some possible causes and solutions.
1. The temperature of the electric motor exceeds
70°C.
The motor has been overloaded by work that is too
big:
- Allow the motor to cool down.
The motor is defective:
- Contact your local Ferm dealer to have the tool inspec-
ted and/or repaired.
2. The tool does not work when switched on.
Damaged cord and/or plug:
- Check cord and/or plug.
Defective switch:
- Contact your local Ferm dealer to have the switch
inspected and/or repaired.
Repairing of electric appliances may be carried out
only by experts.
MAINTENANCE
Make sure that the machine is not live when car-
rying out maintenance work on the motor.
The Ferm machines have been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon pro-
per machine care and regular cleaning.
Cleaning
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots free
from dust and dirt.
If the dirt does not come off use a soft cloth moistened
with soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part, please con-
tact your local Ferm dealer.
In the back of this manual you find an exploded view
showing the parts that can be ordered.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations.
Take your unwanted machines to your local Ferm-
dealer. Here they will be disposed of in an environmen-
tally safe way.
GUARANTEE
The guarantee conditions can be found on the separately
enclosed guarantee card.
4 Ferm Ferm 53