Operation Manual

Ferm 65
Besides, in the table - second column- is mentioned how
the starting size by means of the same change wheels can
be adjusted.
Tab.5
MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the benchlathe
LUBRICATING SCHEDULE
Fig.18
Tab.6
Maintenance of the machine happens for preventing rust
and wear end tear. The maintenance consists mainly of
clearing and oiling. It certainly is not sufficient to handle
only the oil-syringe. Chips and waste of the machine
parts have to be removed very regularly, often more
times during turning. Otherwise there is the possibility it
lands between moving, slipping and turning parts. For
this reason chips bulldozers on the cross slide have been
placed. watch fig.18.
Part
Roller bearing
main shaft
Bearings and cog
wheels of speed
reduction axles in
the headstock (2)
Bearings V-belt
roller and axle
mediate
Thrust bearing
mission (13)
Change gear
wheels (12)
Gear wheels lock
with gear
rack(15)
Gear wheel
bearings lock
case, lock nut
mechanism (17)
Transmission/
starting axle (18)
Sliding surfaces
off the bed (3)
Support spindles
(8, 16)
All ball nipples
the (5,6,9,14 and
20)
Felt in chips
bulldozers (4)
All remaining
white parts
without cover
layer
Time/interval
After first 10 days
after 20 days and
then each 60 days
Annually
Annually
At change or
Weekly
Weekly
Daily
The same
The same
The same
The same
The same
Weekly
Lubricant
Transmission oil
SAE90:
till sight-glass is half
full(1) or lowest cog
wheels just in the
oil
The same
Universel gear
The same
Fine lubricating oil
The same
The same
The same
The same
The same
Vaseline
Inch
n/inch A B C
48 70 79
40 70 84 79
32 105 98 49
2498 40
20708440
16 56 84 40
14 49 105 50
12 49 98 40
11 49 105 39
8 50 105 28
12 Ferm