Operation Manual

ManualsBrandsFerm ManualsSawfes-350

Ferm 15

Lubrication

If it is difficult to rotate the adjustment knob, unscrew it until the rubber seal becomes visible.

Use a soft brush to clean the area around the seal and apply a few drops of synthetic oil to it.

Faults

Contact the maintenance address stated on the warranty card if the saw becomes faulty, for

example, in the case of wear of one of the parts.

An exploded view included at the back of this

instruction manual lists the parts you can order.

Environment

In order to avoid damage during transport, the saw is delivered in strong packaging material.

Where possible, recyclable packaging material has been used.

Therefore, please recycle the

packaging material.

Faulty and/or discarded electrical or electronic tools should be handed over to a

recognized collection point for disposal.

Warranty

See the warranty card in the back of this instruction manual for the warranty terms.

CE DECLARATION OF CONFORMITY (GB)

We declare under our sole responsibility that

FES-350

is in conformity with the following standards or standardized documents:

EN60745-1, EN60745-2-5, EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3

in accordance with the regulations.

98/37/EC, 2006/95/EC, 89/336/EEC, 2002/95/EC, 2002/96/EC

from 01-08-2007

ZWOLLE NL

J.A. Bakker - van Ingen J. Lodewijk

CEO Ferm BV

Quality Manager Ferm Global

It is our policy to continuously improve our products and we therefore reserve the right to

change the product specification without prior notice.

Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • The Netherlands

FIN

114 Ferm

PRÆCISIONSCIRKELSAV FES-350

Numrene i den nedenstående tekst henviser til illustrationerne på side 2 - 5.

For din egen og andres sikkerhed anbefaler vi at du læser denne brugsanvisning

nøje igennem, før maskinen tages i brug. Opbevar denne brugsanvisning og den

øvrige dokumentation ved maskinen.

IIndledning

Denne maskine er beregnet til privat brug og til at save i forskellige slags tynde materialer.

Præcisionscirkelsaven kan bruges, hvis der skal saves præcist og støvfrit eller hvis der er risiko

for at ramme rør eller kabler

. Præcisionscirkelsaven er unik, fordi det materiale, der skal saves

med maskinen bliver klemt fast mellem basispladen og arbejdsbænken. Derefter bliver

savklingen trykket ned i det materiale, der skal saves, hvorved man får et hurtigt, nemt og pænt

resultat.

Indhold

1. Maskindata

2. Sikkerhedsinstruktioner

3. Anvendelse

Service og vedligeholdelse

1. MASKINDATA

Tekniske specifikationer

Spænding | 230 V~50 Hz

Effekt

| 350 W

Savdybde | 0-12 mm

Omdrejningstal, uden belastning | 4000 omdr. pr. minut

Maks. driftscyklus | 3 min/5 min

Reduktion | 8.4:1

Savklinge diameter | 50,8 mm

Vægt | 1,2 kg

Maks. klingediameter | 50,8 mm

Maks./min. klingebredde | 2 mm/ 0,75 mm

Rystefrekvens | < 2,5 m/s

Lydtrykniveau | 86,1 dB(A)

Lydtrykniveau-ækvivalent | 99,1 dB(A)

FIN