Operation Manual

5
EN
Electrical safety
3
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
● Do not use the machine if the mains cable or
the mains plug is damaged.
● Only use extension cables that are suitable for
the power rating of the machine with
a minimum thickness of 1.5 mm
2
. If you use
a extension cable reel, always fully unroll the
cable.
Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/5A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
TECHNICAL DATA
PDM1016
Mains voltage V~ 230
Mains frequency Hz 50
Power input W 1,050
No-load speed min
-1
0 - 1,100 / 0 - 3,000
Impact rate
Drilling min
-1
0 - 17,600
Hammer drilling min
-1
0 - 48,000
Max. drill bit diameter
Wood mm 30
Concrete mm 13
Steel mm 13
Protection class IP 20
Weight kg 3.5
NOISE AND VIBRATION
PDM1016
Sound pressure (L
pa
) dB(A) 89
Acoustic power (L
wa
) dB(A) 100
Uncertainty (K) dB(A) 3
Vibration m/s
2
4.7
Uncertainty (K) m/s
2
1.5
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardised test given in EN 60745; it may be used
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may signicantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signicantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.
1. On/off switch
2. Lock-on button
3. Speed adjustment wheel
4. Forward/reverse switch
5. Switch for mechanical speed
6. Switch for drilling / hammer drilling
7. Chuck
8. Main grip
9. Auxiliary grip
10. Depth stop
11. Carbon brush cover
12. Chuck key
13. Chuck key holder