GRM1013 EN Original instructions WWW.FERM.
6 7 9 8 5 2 1 3 10 4 Fig. 1 Fig.
Fig. 3 Fig.
EN HIGH PRESSURE CLEANER The numbers in the text refer to the diagrams on pages 2-3. or your own safety and that of others, F we recommend that you read this instruction manual carefully before using this machine. Keep this instruction manual and the documentation provided with the machine for future reference. Introduction The high pressure cleaner GRM1013 is quick and efficient for cleaning vehicles, machines, boats, buildings, etc.
EN injury. Read the following safety instructions and also the enclosed safety instructions. Electrical safety • Always check if your mains voltage corresponds with the value on the type plate. • When replacing old cables or plugs: • Throw away old cables or plugs immediately as soon as new ones have replaced these. It is dangerous to put the plug of a loose cable into the socket outlet. • When using extension cables: • Only use an approved extension cable that is suitable for the machine’s power.
EN • This machine has been designed for use with the cleaning agent supplied or recommended by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the machine. • Recommend the operator to wear ear protectors. • Do not use the machine within range of persons unless they wear protective clothing. • Do not direct the jet against yourself or others in order to clean clothes or foot-wear. • Risk of explosion-Do not spray flammable liquids.
EN extension cord before using and replace if damaged. Inadequate extension cords can be dangerous. Do not abuse extension cord and do not yank on any cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the machine from the extension cord. • To reduce the risk of electrocution, don’t start and run the machine in the rain or storm. Keep all connections dry and off the ground. Do not touch plug with wet hands.
EN 5. Disconnect the garden hose from the pressure washer. 6. Wipe all surfaces of the unit with a damp clean cloth. 7. Engage the gun safety lock. CAUTION: ALWAYS turn off the unit’s motor BEFORE turning off the unit’s water supply. Serious damage could occur to the motor if the unit is run without water. CAUTION: NEVER disconnect the high-pressure discharge hose from the machine while the system is still pressurized.
EN water to run on to unwashed surfaces. • Shutting down the pressure washer The use of detergents can dramatically reduce cleaning time and assist in the removal of difficult stains. Some detergents have been customized for pressure washer use on specific cleaning tasks. These detergents are approximately as thick as water. The use of thicker detergents, such as dish soap, will clog the chemical injection system and prevent the application of the detergent.
EN • Suction/ delivery valves are clogged or worn out. • Check that the water feeding hose is not leaking. • Unloader valve is stuck • Clear or respire valves • Lance nozzle incorrect or worn out • Loosen and re-tighten regulation screw Check and/ or replace. Repairs and servicing should only be carried out by a qualified technician or service firm. Cleaning Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Exploded view A Spare parts list GRM1013 No.
Exploded view B 13
DECLARATION OF CONFORMITY GRM1013 - HIGH PRESSURE CLEANER (EN) We declare under our sole responsibility that this product is in conformity with directive 2011/65/EU of the European parliament and of the council of 9 June on the restriction of the use of certain hazardous substances in electrical and electronic equipment is in conformity and accordance with the following standards and regulations: (DE) Der Hersteller erklärt eigenverantwortlich, dass dieses Produkt der Direktive 2011/65/EU des Europäisch
1504-28 WWW.FERM.COM ©2015 FERM B.V.
