GRM1020 EN Original instructions www.ferm.
9 8 7 6 2 5 4 10 Fig. 1 Fig.
Fig. 3 3 Fig. 4 Fig.
EN HIGH PRESSURE CLEANER The numbers in the text refer to the diagrams on pages 2-3. or your own safety and that of others, F we recommend that you read this instruction manual carefully before using this machine. Keep this instruction manual and the documentation provided with the machine for future reference. Introduction The high pressure cleaner GRM1020 is quick and efficient for cleaning vehicles, machines, boats, buildings, etc.
EN Electrical safety • Always check if your mains voltage corresponds with the value on the type plate. • When replacing old cables or plugs: • Throw away old cables or plugs immediately as soon as new ones have replaced these. It is dangerous to put the plug of a loose cable into the socket outlet. • When using extension cables: • Only use an approved extension cable that is suitable for the machine’s power. The cores must have a diameter of at least 1.5 mm2.
EN • • • • • • • • • • • • • • 6 by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the machine. Recommend the operator to wear ear protectors. Do not use the machine within range of persons unless they wear protective clothing. Do not direct the jet against yourself or others in order to clean clothes or foot-wear. Risk of explosion-Do not spray flammable liquids.
EN • • • • • • • • • • • be dangerous. Do not abuse extension cord and do not yank on any cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the machine from the extension cord. To reduce the risk of electrocution, don’t start and run the machine in the rain or storm. Keep all connections dry and off the ground. Do not touch plug with wet hands. It is strictly prohibited to let water leak into the machine.
EN 6. Wipe all surfaces of the unit with a damp clean cloth. 7. Engage the gun safety lock. CAUTION: ALWAYS turn off the unit’s motor BEFORE turning off the unit’s water supply. Serious damage could occur to the motor if the unit is run without water. CAUTION: NEVER disconnect the high-pressure discharge hose from the machine while the system is still pressurized.
EN Water inlet filter Fig. 4 • The water inlet filter must be inspected regularly, so as to avoid blockage and restriction of the water supply to the pump. (fig 4) Using the detergent bottle Fig. 5 • Add detergent to the container. • Set the Adjustable Spray Wand at low pressure position. • Trigger gun to spray detergent. The use of detergents can dramatically reduce cleaning time and assist in the removal of difficult stains.
EN overheat. Leave to cool down. Use heavy duty extension cables. 5. The pump does not reach the necessary pressure. • Water inlet, filter is clogged • Clean the water inlet filter • Pump sucking air from connections or hoses • Check that all supply connections are tight • Suction/ delivery valves are clogged or worn out. • Check that the water feeding hose is not leaking.
Exploded view A Spare parts list GRM1020 No.
B 13A Exploded view B 13
DECLARATION OF CONFORMITY GRM1020 - HIGH PRESSURE CLEANER (EN) We declare under our sole responsibility that this product is in conformity with directive 2011/65/EU of the European parliament and of the council of 9 June on the restriction of the use of certain hazardous substances in electrical and electronic equipment is in conformity and accordance with the following standards and regulations: (DE) Der Hersteller erklärt eigenverantwortlich, dass dieses Produkt der Direktive 2011/65/EU des Europäische
1508-28 www.ferm.com ©2015 FERm B.V.
