User manual

4
EN
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable
of the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
2. MACHINE INFORMATION
Intended use
Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.
Technical specifications
Mains voltage 230-240 V~
Mains frequency 50 Hz
Power input 1010W
No-load speed (1) 0-1.000 /min
No-load speed (2) 0-3.000 /min
Impact rate (1) 0-16.000 /min
Impact rate (2) 0-48.000 /min
Max. chuck size 13 mm
Max. drill diameter
Wood 40 mm
Concrete 16 mm
Steel 13 mm
Weight 2.77 kg
Noise values
Sound pressure (L
PA
) 87.36 + 3 dB(A)
Acoustic power (L
WA
) 98.36 + 3 dB(A)
Vibration values
Drilling into metal, a
h,D
10.667 + 1.5 m/s
2
Impact drilling into concrete, a
h,ID
13.957 + 1.5 m/s
2
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in

with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3.
Fig. A
1. Chuck
2. Function selection switch
3. Depth stop
4. Lock-on button

6. Speed adjustment wheel

8. Gear selection switch
9. Side handle
10. Function selection: Hammer drilling
11. Function selection: Drilling
Fig. B
12. Rear sleeve
13. Front sleeve
3. OPERATING
Impact drills require very little operator
pressure. Excessive pressure on the tool
can lead to unnecessary overheating of
the motor, and burning of the driven tool.