User manual

5
EN
Side handle
Fig. A
The side handle (9) can be rotated 360
0
around
the drill head, enabling safe and comfortable
operation for both left and right-handed users.
• Loosen the side handle (9) by turning it
anticlockwise.
• Rotate the side handle to the desired position.
• Retighten the side handle in the new position
by turning it clockwise
Exchanging and removing drill bits
Fig. A - B
Before exchanging bits, first remove the
power plug from the wall socket.
Inspect bits regularly during use. Blunt
bits should be re-sharpened or replaced.
 
sleeve (13) clockwise while simultaneously
holding the rear sleeve (12) or turning it
counterclockwise and insert the bit into the
chuck opening.
• Tighten the bit by turning the front sleeve (13)
counterclockwise while simultaneously holding
the rear sleeve (12) or turning it clockwise.

couple of “clicks” once the bit is tightened.
Setting depth stop
Fig. A
• Loosen the side handle (9) by turning it
counterclockwise.
• Insert the depth stop (3) through the hole in the
side handle ring.
• Slide the ruler to the desired depth.
• Retighten the screw firmly by turning it
clockwise
The On/Off switch
Fig. A
 


• The rotation-speed can be adjusted by

raising the rotation-speed or release pressure
for lowering the rotation-speed.
Lock-on Button
Fig. A
 

lock-on button (4).
 

Adjusting of the maximum rotation speed
Fig. A
 

 
lock-on button (4).
• Adjust the speed by turning the speed
adjustment wheel (6) to the desired maximum
rotation speed.
Switching the direction of rotation
Fig. A
Do not change the direction of rotation
during use.
• Direction of rotation counter-clockwise: shift
 ”.
 
rotation switch (7) to “ ”.
Function selection switch
Fig. A
In order to avoid damage to the machine,
adjusting the function selection switch (2)
shall only be done when machine is not
running
• Set the function selection switch (2) to (11) for
drilling.
• Set the function selection switch (2) to (10) for
hammer drilling.
Gear selection switch
Fig. A
In order to avoid damage to the machine,
adjusting the gear selection switch (8)
shall only be done when machine is not
running.