User manual
6
EN
• If you set the gear selection switch (8) to
position “1”, the drilling speed can be adjusted
• If you set the gear selection switch (8) to
position “2”, the drilling speed can be adjusted
• When the gear selection switch (8) cannot
switch easily between “1” and “2”, give the
chuck (1) a little spin by using your hands. This
will help the gears fall into the correct position
and makes switching the gears easier.
User tips
Always use the machine with the side handle
firmly anchored in place - you will not only work
with more comfort, you will also work with more
precision.
Caution: drilling bits and hammer drilling
bits can get very hot
Drilling and hammer drilling
• For large holes, for instance in very hard
concrete, start using a smaller bit for pilot
drilling first , then drill to nominal size.
• Hold the machine firmly with 2 hands. Be
aware the drill can jam and because of that
machine might suddenly turn (Especially when
drilling deep holes).
• Do not apply a lot of pressure on the machine,
let the machine do the work.
4. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia,
etc. Chemicals such as these will damage the
synthetic components.
Carbon brush
If the carbon brushes are worn, the carbon
brushes must be replaced by the customer
service department of the manufacturer or a
similarly qualified person.
Only use the correct original type of
carbon brushes.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Defects
The machine should be regularly inspected for
the following possible defects, and repaired if
necessary.
• Damage to power cord
• Short circuiting
• Damaged moving parts
WARRANTY
The warranty conditions can be found on the
separately enclosed warranty card.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.