User manual

8
EN
• Switchonthesawbench.
• Feedtheworkpiece,withoutimposing
pressure on it, towards the saw blade. Support
the section of the workpiece that has already
passed the saw to ensure that it does not fall.
• Whentherearedgeoftheappliancecomes
close to the saw blade, use the push stick (B)
to feed the workpiece further. Use at all times
the push stick for small workpieces.
• Switchoffthesawbenchwhenyouhave
sawed the workpiece.
Mitre guide
Fig. 6
The mitre guide (A) allows you to place the
workpiece on the table at an angle of 45° allowing
diagonal saw cuts to be made. You can for this
purpose secure the mitre guide to the guide (B)
(Fig. 6).
5. MAINTENANCE
During maintenance and cleaning always
remove the mains plug from the socket.
Never use liquids when cleaning
electrical parts of the saw bench.
The machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Malfunctions
The electric motor becomes hot.
• Themotorisbeingoverloadedbyworkpieces
that are too big.
• Sawatalowerspeedsothatthemotorcan
cool down.
• Theventilationgridofthemotorisblocked.
• Cleantheventilationgrid
• Themotorisdefective.
• Pleasecontacttheserviceaddressonthe
warranty card.
The appliance does not work when connected.
• Themotorhasbeenswitchedoffbythe
thermal cutout.
• Allowtheapplliancetocooldownandswitchit
on again.
• Themainsconnectionhasbeenbroken.
• Checkthemainsconnectionforfaults.
• Theswitchisdamaged.
• Pleasecontacttheserviceaddressonthe
warranty card.
It is very difficult to move the workpiece along
the saw blade in a straight line and the saw cut
is uneven.
• Thesawbladeiswarpedorblunt.
• Replacethesawblade.
• Theripfenceisnotproperlysecured.
• Cleantheripfenceandsecureitinthecorrect
way.
The workpiece starts to vibrate violently during
sawing.
• Thesawbladeisoverheatedordistorted.
• Replacethesawblade.
Maintain the saw bench on a regular
basis as this will prevent unnecessary
problems.
The following will ensure that your appliance
remainsinoptimumcondition:
• Emptythedust-collectionbinregularly.You
can remove the bin readily by loosening the
two attachment screws.
• Keepthesawbladecleantoavoid
irregularities in the saw cut.
• Inspectthesawbladeregularlyforcracks,
fractures and broken or blunt teeth. Replace
damaged saw blades immediately.
• Keeptheventilationgridofthemotorcleanto
avoid the motor becoming overheated.
• Replacetheinsetpiecewhenitisworn.
Cleaning
Keeptheventilationslotsofthemachinecleanto
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
aftereachuse.Keeptheventilationslotsfreefrom
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.