User Manual

7
EN
Kickback is the upward and backward movement
of the cutting discs when the cutting discs
unexpectedly touch an object. Securely hold the
machine with both hands during use. Keep your
attention focused on the operation.
Kickback is usually caused by:
- unintentionally touching hard objects or
materials with the rotating cutting discs;
- blunt cutting discs;
- cutting discs that are not properly mounted;
- cutting into a previous cut;
- a lack of attention to the operation;
- an instable stance.

● Donotlookdirectlyintothelaserbeam.
● Donotpointthelaserbeamhumansoranimals.
● Donotpointthelaserbeamatstrongly
reectingmaterial.
● Donotinserthardobjectsintothelaseroptics.
● Cleanthelaseropticswithasoft,drybrush.
● Onlyhavethelaserrepairedbyaqualied
technician.
ELECTRICAL SAFETY
3
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
● Donotusethemachineifthemainscableor
the mains plug is damaged.
● Onlyuseextensioncablesthataresuitablefor
the power rating of the machine with a
minimum thickness of 1.5 mm
2
.Ifyouusea
extension cable reel, always fully unroll the
cable.

Ifthemoulded3-pinplugattachedtotheunitis
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approvedBS1363/13Afusedplugandthatthe
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
theletterNorcolouredblack.
- The wire which is coloured brown must be
connected to the terminal which is marked with
theletterLorcolouredred.
TECHNICAL DATA
 
Mainsvoltage V~ 230
Mainsfrequency Hz 50
Powerinput W 1,700
No-loadspeed min
-1
 4,000
Slotwidth mm 14/19/29
Slotdepth mm 0-28
Cuttingdisc
 Diameter mm 125
Bore mm 22.2
Spindlethread  M12
Protectionclass  IP20
Laserclass  2
Battery type AAA
Weight kg 5.1
NOISE AND VIBRATION
 
Soundpressure(L
pa
) dB(A) 101.88
Acousticpower(L
wa
) dB(A) 112.88
Uncertainty(K) dB(A) 3
Vibration(maingrip) m/s
2
 9.43
Vibration(auxiliarygrip) m/s
2
 9.564
Uncertainty(K) m/s
2
1.5
2
Wear hearing protection.

The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardisedtestgiveninEN60745;itmaybeused
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
maysignicantlyincreasetheexposurelevel
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signicantlyreducetheexposurelevel