User Manual

8
EN
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
yourhandswarm,andorganizingyourwork
patterns

Your wall slotter has been designed for making
slots in masonry. The machine is only suitable for
right-hand use.
 1. On/offswitch
 2. Lock-offbutton
 3. Lockingknobforslotdepth
4. Scale for slot depth
5. Spindle lock button
6. Guard
 7. On/offswitchforlaser
 8. Laser
 9. Batterycompartment
10. Base
11. Guide roller
12. Dustextractionconnection
13. Maingrip
14. Auxiliary grip

4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.

Worn or damaged cutting discs must be replaced
immediately.
2
- Onlyusesharpandundamagedcuttingdiscs.
- Onlyusecuttingdiscsthataresuitableforthe
material to be worked.
- Onlyusecuttingdiscswithamaximum
permitted speed that is equal to or exceeds
the maximum no-load speed of the machine.
- Onlyusediamondcuttingdiscsthatare
suitable for dry cutting.
- Always replace both cutting discs at the same
time.
- Neverattempttoremovetheguard.
● Placethemachineonastablesurface.
● LoosentheAllenscrews(15)usingtheAllen
key (16).
● Loosenthelockingknob(3)andlowerthe
base(10).
● Removetheguard(6).
● Keepthespindlelockbutton(5)pressedto
lock the spindle (17).
● Loosentheouterange(18)usingtheange
key(19).
● Removetheoldcuttingdisc(20),thespacers
(21), the old cutting disc (22), the spindle
sleeve(23),andtheinnerange(24).
Ifnecessary,usethesplittingwedge(25)to
remove the spacers (21).
● Ifnecessary,cleantheanges(18&24).
● Mounttheinnerange(24),thespindlesleeve
(23),thenewcuttingdisc(22),thespacers
(21),andthenewcuttingdisc(20).
● Firmlytightentheouterange(18)usingthe
angekey(19).
● Releasethespindlelockbutton(5).
● Mounttheguard(6).
● Raisethebase(10)andtightenthelocking
knob(3).
● FirmlytightentheAllenscrews(15)usingthe
Allen key (16).


The slot width can be set using the spacers
between the cutting discs. The number of spacers
between the cutting discs determine the slot width.
2
- Donotsettheslotwidthduringuse.
- Always mount at least one spacer between the
cutting discs.
● Determinetheslotwidth.
● Mountthespacers(21)aroundthecutting
discs(20&22)intherequiredorder.Referto
thechapter“Replacingthecuttingdiscs”.

Theslotdepthisvariablebetween0and28mm.
The slot depth can be read from the scale (4).
2
Do not set the slot depth during use.
● Slackenthelockingknob(3).
● Tiltthebase(10)totherequiredposition.Set
aslotdepthapproximately3mmdeeperthan
the required depth to compensate for possible
unevenness of the wall surface.
● Tightenthelockingknob(3).

● Toswitchonthemachine,keepthelock-off
button (2) pressed and simultaneously press