SDS

Page: 4/10
Leak Sealer F4 Express 400ml
Section 6. Accidental release measures
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal.
Large spill
:
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe
storage, including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Store in accordance with local regulations. Store away from direct sunlight in a dry, cool
and well-ventilated area, away from incompatible materials (see Section 10) and food
and drink. Protect from sunlight. Use appropriate containment to avoid environmental
contamination. See Section 10 for incompatible materials before handling or use.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Pressurized
container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do
not pierce or burn, even after use. Do not ingest. Avoid contact with eyes, skin and
clothing. Avoid breathing gas. Avoid breathing vapor or mist. Use only with adequate
ventilation. Wear appropriate respirator when ventilation is inadequate. Empty
containers retain product residue and can be hazardous.
:
Precautions for safe handling
None.
Section 8. Exposure controls/personal protection
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: safety glasses with side-
shields.
Eye/face protection
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Use only with adequate ventilation. If user operations generate dust, fumes, gas, vapor
or mist, use process enclosures, local exhaust ventilation or other engineering controls
to keep worker exposure to airborne contaminants below any recommended or statutory
limits.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Control parameters
Individual protection measures
Occupational exposure limits
Skin protection
Continued on next page