Instructions / Assembly
FERVOR ASSEMBLY TIPS
BEFORE ASSEMBLY:
1. It is helpful to have the following items available to you:
a. Philips head screwdriver – magnetic preferred
b. Wrench – 5mm or adjustable
c. Flashlight
d. Work bench, table or other surface at least 25” high – optional but recommended
2. First open the box carefully and lay all parts on a soft surface such as a blanket and in a well-lit area.
3. There are two Bolt Packs. One is labeled as additional hardware and is only used if needed. The
attached diagrams will help identify the hardware in the main Bolt Pack.
4. Check that all pieces are there according to the diagram on the front of the instructions.
5. Use care in handling the “Drawer Slides” as the ball bearing mechanisms are sensitive.
6. If you use a raised surface as listed above, the assembly of the base will be easier so that you can
avoid repetitive bending over or kneeling.
DURING ASSEMBLY:
2. Please note: the image of the assembly on Step 1 is misleading. The locking castors belong at the
rear of the grill base. They are placed opposite from the rolled edge.
!"#
4. When attaching the magnets on Step 5, be careful to not overtighten the screws as this could over
stress or break the plastic molded part or strip the threads.
5. On Step 14, do not fully tighten the brackets at this time. They are tightened during Step 17.
BEFORE GRILLING:
1. Check that all gas lines are connected properly according to the assembly instructions.
2. Read the Owner’s Guide completely.
3. Wipe down the grill with warm water and a mild soap.
$%&'
Outdoor Living Made Easy