Instruction Manual

4. Commissioning
4−25
Festo P.BE−SPC200−COM−PDP−E N en 0901c
Configuring the Slave properties
After clicking the symbol for the SPC200, you can configure
the Slave properties" in the lower part of the screen. Here
you can determine the number and size of the I/O ranges of
the slave and assign them with address ranges of the master.
In order to configure the
Slave proper ties of the SPC200:
1. open the permitted identifiers in the hardware catalogue
under Festo SPC200
2. then use the mouse to pull the desired identifier into the
appropriate line under Module/DP identifier.
When configuring the I/O address range, observe the rules in
section 4.4.2.