User Manual

19
cleaning the saw blades.
Resharpened saw blades
The cutting depth of resharpened saw blades can
be adjusted accurately using the adjusting screw
[11-1] .
 Adjust the cutting depth stop [11-2] to 0 mm
(with guide rail).
 Unlock the saw unit and push downwards until
it reaches the stop.
 Turn in the adjusting screw [11-1] until the saw
blade touches the workpiece.
Saw table wobbles
 The saw table must be on an even surface when
adjusting the cutting angle.
If the saw table wobbles, the setting must be performed
again (Chapter Adjusting the cutting angle ) .
Accessories
Use only original Festool accessories and Festool
consumable material intended for this machine.
These components are designed specifically for
this machine. Using accessories and consumable
material from other suppliers will most likely affect
the quality of your results and limit warranty
claims. Machine wear or your own personal work
-
load may increase depending on the application.
Protect yourself and your machine, and preserve
your warranty claims by always using original Fes-
tool accessories and Festool consumable material!
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festoolusa.com".
Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all applica
-
tions that are specially designed for your Festool
portable circular saw.
Parallel stop, table widener
A parallel stop can be used for section widths up to
180 mm. The parallel stop can also be used as a ta
-
ble widener.
Side-mounted cover, false joints
The cover that can be mounted on the side of the
protective cover improves the effect of dust ex-
traction for 0° cuts.
Simultaneously, the cover can be used as a false
joint stop for false joint widths from 18 mm on-
wards.
Guide system
The guide rails, which are available in different
lengths, allow for precise, clean cuts and simulta
-
neously protect the workpiece surface against
damage.
In conjunction with the extensive range of accesso-
ries, exact angled cuts, mitre cuts and fitting work
can be completed with the guide system. The option
11
11-1
11-2