User Manual

s = 8
s = 8
s = 12
s = 12
www.festool.co.uk
Total length (mm)
Working length (mm)
Cutter diameter (mm)
Shank diameter (mm)
Chamfering angle (°)
Radius (mm)
Marking for minimum clamping length
n max. = Maximum routing speed
Packaging unit
Tungsten carbide
High performance, high speed steel
Flute cutter
with ball bearing s = 8
Round nose cutters
s = 8
Reversible blade chamfer/
edge-trimming cutter
with ball bearing
s = 8
Hand hole cutter
with ball bearing s = 8
Ovolo edge cutters
s = 8
Half-round cutter
with ball bearing s = 8
Finger pull cutter
s = 8
Roundover-chamfer cutter
with ball bearing s = 8
Round nose cutter
with ball bearing s = 8
ØD NL GL R Fα Order No.
25.5 12.7 54 6.35 – 491018
28.8 14 56 8 – 491019
31.7 14.3 56 9.5 – 491020
38.1 16 57 12.7 – 491021
ØD NL GL R Fα Order No.
30.5 12 62 – 45° 491084
ØD NL GL R Fα Order No.
17.5 19 61.5 6 15° 491134
23.1 19 60.5 6 30° 491135
31.4 18.5 60.5 6 45° 491136
ØD NL GL R Fα Order No.
19 32 68 16 – 491033
ØD NL GL R Fα Order No.
22 16 59 2.5 6 491140
ØD NL GL R Fα Order No.
17 10 40 3 – 491004
19 11 41 4 – 491005
21 12 42 5 – 491006
23 13 45 6 – 491007
27 15 45 8 – 491008
ØD NL GL R Fα Order No.
27 30 70 12 – 491139
ØD NL GL R Fα Order No.
16 25 65 5 – 490981
ØD NL GL R Fα Order No.
19 16 53 6.4 – 490982
ØD NL GL R Fα Order No.
8 8 38 4 – 490983
12.7 10 40 6.35 – 490984
16 11 41 8 – 490985
19.4 11 41 9.7 – 490986
25.4 14 44 12.7 – 490987
25.4 18 58 12.7 – 491103
30 20 60 15 – 491104
40 25 65 20 – 491105
ØD NL GL R Fα Order No.
20 14 54 – 10° 491023
25.7 25.1 70 – 15° 491132
24 10 50 – 30° 491024
38.5 23 64.5 – 30° 491133
36 11.5 53 – 45° 491025
44 30 80 – 30° 491101
55 26 76 – 45° 491102
Flute cutters
s = 8/s = 12
Chamfer cutter
with ball bearing s = 8/s = 12
19
2011_GB_en_FB_Routing.indd 19 06.05.11 16:30