Operation Manual

CXS
13
GB
– drilling in metal, wood, plastic and similar mate-
rials,
– inserting and tightening screws
Charger MXC suitable
– for charging the listed battery packs.
– only for indoor use.
The user is liable for improper or non-in-
tended use; this also includes continuous in-
dustrial operation.
6Operation
6.1 Changing the battery pack [2]
 Battery pack is ready for use immediately upon
delivery and can be charged at any time.
 Side of the belt clip [2-1] can be replaced when
battery pack is removed.
6.2 Charging the battery pack [3]
The LED [3-1] on the charger indicates the respec-
tive operating status of the charger.
7 Settings
7.1 Changing direction of rotation [1-5]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Changing gear [1-4]
• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
7.3 Adjusting torque [1-1]
The arrow [1-3] aligns with the adjusted state.
Drilling
Drilling symbol [1-2] on adjustment ring aligns
with the arrow = maximum torque..
Fastening
Torque corresponding to setting:
Position 1 = low torque
Position 12 = high torque
8 Tool holder, attachments
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
8.2 Chuck BF-FX8 [5]
For clamping drill bits and bits with max. shaft di-
ameter of 8 mm.
Clamp tool centricly in the chuck.
8.3 Elbow adapter XS-AS [6]
(accessories) Drilling and screwdriving at right an-
gle to machine.
 You can engage the elbow adapter in 16 different
angle settings.
8.4 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
9 Working with the machine
9.1 On/Off switch [1-6]
Press = ON, release = OFF
 The speed of the machine depends on how far
the on/off switch is pressed in.
LED yellow - continuous light
Charger is ready to use.
LED green - light flashes quickly
Battery pack is charged to maxi-
mum capacity.
LED green - light flashes slowly
Battery pack is charged to 80% and
with reduced current.
LED green - continuous light
Battery pack is charged.
LED red - light flashes
General fault indicator, e.g. incom-
plete contact, short circuit, defec-
tive battery pack, etc.
LED red - continuous light
Battery temperature is outside per-
missible limit values (0 °C to 45 °C).
WARNING
Risk of injury
 Always switch off the machine before adjusting
settings!
WARNING
Risk of injury, electric shock
 Always disconnect the battery pack before any
type of work on the machine!