User Manual

33
EN
10.3 Cleaning of the toe kick cover, filter
and condenser.
It is recommended to perform the following cleaning
steps very 6 months. An audio and visual message
on the display will serve as a reminder.
It is possible to disable the warning signal and see
the time left before the next cleaning has to be done.
Behind the frontal toe kick cover there is the
condenser.
To clean it use a vacuum cleaner with a soft brush
attachment at maximum power, sweeping it along
the vent slits. In case of a significant dust build up,
the toe kick cover can be removed to allow a more
accurate cleaning of the filter.
On the mantenience settings,
MAINTENANCE SERVICE
INFO SYSTEM
after the
installation of the unit and after it has been turned
on, you can set the condenser cleaning warning.
In the case the warning sign is enabled, there
will be an audible signal every 6 months,
alerting that it is time to clean the condenser.
After cleaning it, touch the reset icon in order
to reactivate the warning signal in 6 months.
If you do not want the cleaning signal
alert for the condenser, touch the O icon.
Upper condenser.
For cleaning the condenser follow the instruc-
tions:
> Switch o the appliance by pressing the Unit
button
on the main control panel for approx
3 seconds.
> Wait approx 30 minutes, until the finned
condenser cools down to room temperature.
> Lifting up the removable grille.
> Clean it thoroughly from any dust build up as
shown in the picture, taking care not to damage it.
> Restart the unit pressing for 3 seconds on the on
button
.
Warning
The edges of the condenser are sharp,
therefore use adequate protection for the
hands and arms when cleaning the con-
denser.