Installation Guide

35
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222) www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
Check that all adhesive tape and external or in-
ternal temporary protective devices have been re-
moved.
Check the perfect closing of the doors and the
smooth sliding of the drawers and shelves.
7.5 Start up
> To start the appliance, connect the plug to the
electrical mains: at this point, when opening the
door, the control panel will usually visualize the
message “Stand by”, and all the panel keys will
be off
>To turn on all the appliance compartments,
press the Unit button for three seconds. The
display will show the message “Initial test” for
approximately 2 minutes. After this, the com-
pressors will start up and remain on until the
compartment set temperatures are achieved.. Do
bear in mind that this condition could last several
hours during which time the display will continue
to flash the ‘Start Up Phase’ message.
> If the appliance is provided with an Ice Maker,
prior to switching it on make sure that the water
filter cartridge is installed (unless water supply
source is already filtered by other means such as
reverse osmosis).
> Purge air from the water lines by performing
the ‘Manual Clean’ function from the Menu-
>Functions->Water Filter options. You may need
no longer heare this sequence several times un-
til you no longer hear air sputtering from the ice
maker fill tube (Refer to your Use & Care Manual)
or YouTube for more information on the functions
and settings of your appliance.
> Once you are satisfied that the system is pur-
ged of air, switch the Ice Maker on Refer to the
Use & Care Manual included with your appliance
for how to enable the ice maker (if equipped).
Note: If the TriMode drawer is configured as
a Fridge or a Fresco compartment the ice
maker will be disabled. Default mode for
the TriMode drawer is Freezer.
> For further information about the appliance
operation, refer to the User Manual.
If at the first start - up the message Stand
by does not appear, but other messages ap-
pear, such as Fridge too warm, Fresco too
warm, Freezer too warm, or sound signals
are activated, it means that the appliance
has already previously started the cooling
process. If this is the case, deactivate any
possible acoustic signals by pressing the
Alarm button, close the door and wait until
the set temperature is reached.
It is necessary to let the unit reach the correct
temperature before foods are stored inside.
On models with a dedicated Fresco com-
partment, the Fresco compartment cools to
the set temperature (default 0°C / 32°F) prior
to the cooling system switching to the main
refrigeration compartment.
Fhiaba is constantly researching new way to im-
prove the features and the design of their products,
therefore models are often upgraded and revised.
7. COMPLETING THE INSTALLATION
EN
Serigraa B02919202 VETRO USER 599 TFT - FHIABA
Limite per graca parti retro-illuminate - la parte bianca è trasparente
Testo e graca
00
°C+
Impostazioni
Funzioni
00
°C+
00
°C-
Colore SMEG
colore C71
cambiamento dimensioni foro
56x43mm 29-05-2019
lati obliqui 30-03-2020
icone ridotte 29-05-2019
BISELLATURA SUI 4 LATI
BISELLATURA SUI 4 LATI