Installation Guide

31
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222) www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
> Access the back of the appliances to mount the
joining brackets: fix one side of the top and lower
brackets to one of the appliances and subsequently
to the other [ 2 ].
> Next join them at the front attaching the two
profiles with the supplied screws or rivets [ 3 ] .
Attach the bracket on top of the units (if applicable)
as per figure [ 4 ].
> Finish o by mounting the central profile cover
onto the central profiles, by pushing it until a click
is heard [ 5 ].
> Once completed, push the units into their final po-
sition [ 6 ].
If the units are to be installed inside a niche or
within an enclosed structure, it is necessary to
accommodate air flow at the back of the niche to
assure proper ventilation at the back of the unit of
about 5mm. Always mount front panels on door and
drawer before pushing the unit into its final position
inside the niche or structure.
> Check the levelling of the appliance, adjusting its
feet and wheels to correct it.
> Secure the appliance to the adjacent cabinets by
screwing through the side profiles trims factory-
installed on the appliance [ 7 ] or the plastic brack-
ets included with the appliance that are installed
by you. To make this operation easier keep the door
and the drawer open.
> Mount the covering frames onto the profiles, first
insert them laterally and then push firmly until a
“click” is heard [ 8 ].
Take care as appliances will be front-
heavy and may tip with doors and draw-
ers open before they are secured to the
adjacent furniture.
EN
5
7
8
6
2
3 4