Installation Guide

33
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222) www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
7.1 Anti-tipping safety assembly
If the appliance(s) is/are not connected
through the side profile trims to secured
cabinetry you must install the anti-tip
brackets to ensure the product does not fall
forward during use and cause damage or
injury. Failing to secure the appliance(s) se-
curely will void any warranty claim attribut-
able to a tipping situation.
Operate as follows:
> The brackets should be applied as illustrated us-
ing the provided screws If using the anti-tip brack-
ets, lag into wood framing or concrete - drywall will
not hold the weight of appliance.
Place a bracket on the top of the appliance in corre-
spondence to the fixing holes and against the wall
[ 1 ].
> Mark up the holes position on the wall [ 2 ].
> Drill the wall with an 8 mm (3/8”) bit and insert
the expansion plug [ 3 ].
7. COMPLETING THE INSTALLATION
> Reposition the bracket and fix it first to the cabi-
net and then to the wall [ 4 ].
In order to use the anti-tip brackets on the
top compressor models, it will be neces-
sary to temporarily remove the top, metal
ceiling / shield to access the bolting points
for the brackets./ shield to access the bolt-
ing points for the brackets.
7.2 Mounting the handles
on stainless front
To mount the handles onto the door and
the drawer operate as follows:
Operate as follows:
> Insert the handle ends onto the supports alrea-
dy installed on the door and the drawer [ 1 ].
> Screw in the Allen screws available on the handle [ 2 ].
The screws must be tightened in by means of a
2.5 mm (1/8”) hex key or bit.
EN
2 x
6 x
152 (6”)
59 (
2
3⁄8
”)
45 (1
5⁄8
”)
1
2
3
4
1
2