User Manual

Chart 2 Functions
2.4 Support various securities
2.4.1 Wireless LAN security
This device provides four security functions as below.
These securities can be configured through System Summary or Settings.
WEP
RC4, 64bit and 128bit network authentication.
WEP/802.1x
RADIUS authentication and WEP security.
WPA/802.1x
A security combining with RADIUS authentication and WPA (Wi-Fi Protected Access).
WPA-PSK
A security combining with WPA (Wi-Fi Protected Access) codec and WPA-PSK authentication
(Pre-Sheared Key).
Regarding to the settings of WLAN Security functions,
" 5.1.4 WLAN Port Settings " .
2.4.2 Other securities
Except the WLAN security functions in 2.4.1, this device provides the securities (packet filtering)
This security can be configured in System Summary.
L2 ACL
It is the function, which registers the access control list (ACL) of the layer 2 (MAC of the WLAN
device), and carries out packet filtering regarding to the registered ACL.
Access of the WLAN device to this equipment is controllable by using this function.
A
P
Packet Filtering (Inbound)
This function performs filtering control regarding the packet relayed from the WAN side circuit
to the LAN/ WLAN side circuit to IP packet level (IP address or protocol type) regarding to the
security policy rule defined in advance.
AP
Packet Filtering (Outbound)
This function performs filtering control regarding the packet relayed from the LAN / WLAN side
circuit t o the WAN side circuit t o IP packet level (IP address or protocol type) regarding to the
security policy rule defined in advance.
Regarding to the settings of L2 ACL and a Packet Filtering function
"5.2 System Security ".
Please refer to
2-4