User Manual

4 System Configuration
4.2 System Security
4.2.1 Access Control
4.2.1.1 Firewall
Item Default value Range
AP
Firewall Enable
Disable
Enable, Disable
(AP:SS38(AP Mode)
There is no Firewall Enable setting in
SS38(AP Mode)
IF you want to use L2 ACL function, please
start "System Security Wizar
d
"(refer to 7.1.1 Setting Wizard) to enable "L2 ACL Status".
4.2.1.2 L2 ACL
(AP:SS38(AP Mode)
Item Default value Range
AP
Status (Enable ACL function)
Disable
Enable, Disable
Table Policy (Table policy)
Deny
Grant, Deny
L2 ACL Table
(none)
The maximum of 256 entries
MAC Address(MAC address for L2 ACL)
(none)
MAC address format
4.2.1.3 Packet Filtering (inbound)
(AP:SS38(AP Mode)
Packet Filtering Inbound Table
(Inbound table list)
Status (Enable Inbound Filter)
Table Policy (Inbound table policy)
Item
(none)
Disable
Grant
Default value
The maximun of 64 entries
Enable, Disable
Grant, Deny
Range
AP
Source IP From
(The head of the source IP address of the policy)
(none)
IP address format
Source IP To
(The last of the source IP address of the policy)
(none)
IP address format
Source Port From
(The head of the source port number of the policy)
(none)
0~65535
Source Port To
(The last of the source port number of the policy)
(none)
0~65535
Destination IP From
(The head of the IP address of the policy)
(none)
IP address format
Destination IP To
(The last of the IP address of the policy)
(none)
IP address format
Destination Port From
(The head of the address port number of the policy)
(none)
0~65535
Destination Port To
(The last of the address port number of the policy)
(none)
0~65535
Protocol Type
(The protocol type of the policy)
(none) (*1)
TCP, UDP, ICMP
(*1)TCP is set up automatically at the time of new entry generated.
4-7