User Manual

5 Setup the device
5.2.1.4 Packet Filtering (Outbound)
Packet Filtering (Outbound)
According to the security policy, it filters when using the header information of the layer 3 (L3) and
layer 4 (L4) of an outbound packet.
The security policy will be setup according to Packet Filtering Outbound Table.
If set as Grant, the packet, which was the same with the registered filter conditions, will be relayed.
The packet, which doesn't correspond to filter conditions, will be canceled.
If set as Deny, the packet, which was the same with the registered filter conditions, will be canceled.
The packet, which doesn't correspond to filter conditions, will be relayed.
To add: Click here.
Packet Filtering Table ( Before the edition)
Displays the existing entries. Each entry contains a source IP, source port, destination IP, destination
port, protocol type and the priority.
You can edit the priority and delete the entry from this table.
The entry which checked in the "In Used" box is used for packet filtering, and the entry without the
check will be ignored.
If you want to change the value of "Priority" box, please click "Update" button and the priorty
of each entry will be changed.
5-29