User's Manual

12
parameter will not be active. Infrastructure Client nodes will always go to
the same channel as their AP.
Wired Equivalent Privacy
• If you would like to enable WEP, click the encryption button.
• You may desire additional measure of security in your wireless network, which can be
achieved by using the Wired Equivalent Privacy (WEP). Follow the steps below to set
your WEP: Select the data privacy algorithm you want (64 or 128 bit WEP type). If
you select 64 or 128 bit WEP type, 4 sets of WEP key will be generated; if you select
disable , then profile encryption will not active.
Country
• Every country has different legal frequency range. Please choose proper country setting.
Under the infrastructure mode, the setting value will be determined by the Access Point
and can’t be set by users.
2.2.2. WLAN Management Utility Introduction
1. Status Tab
The Status tab provides information on the current profile, if any, being used in
the wireless connection. The information listed on the Status tab is indicated below.
Figure 1 shows the screen layout of the Status tab.