Manual
•
System Reset
•
Speed Volume
•
On Volume Limit
Press the MENU button again to exit the Menu function.
Speed Volume Function — If Equipped
This function automatically adapts the volume level to
the speed of the car, turning up the volume when the
speed increases to maintain the ratio with the noise level
inside the passenger compartment. To activate/
deactivate the function, use the buttons. The wording
“Speed volume” appears on the display, followed by the
current status of the function:
•
Off: function deactivated
•
Low: function activated (low sensitivity)
•
High: function activated (high sensitivity).
On Volume Limit
This function makes it possible to activate/deactivate the
maximum volume limit when turning the radio on.
The display shows the function status:
•
“On volume limit: on” – when the radio is turned on
the volume level will be:
−
if the volume level is equal to or higher than the
maximum value, the radio will come on at the maxi-
mum volume;
−
if the volume level is between the minimum and
maximum values, the radio will come on at the same
volume as before it was switched off;
−
if the volume level is equal to or lower than the
minimum value, the radio will come on at the mini-
mum volume.
13
•
“On volume limit: off” – the radio will come on at the
same volume as before it was switched off. The
volume level can be between 0 and 40.
Use the buttons / to change the setting.
NOTE:
•
Using the Menu it is only possible to adjust the
activation/deactivation of the function and not the
minimum or maximum volume value.
•
If the battery charge is too low, the volume cannot be
adjusted between the minimum and the maximum
level.
Radio Off Function
This function makes it possible to set the radio switching
off mode by choosing between two methods.
The chosen mode appears on the display:
•
“Radio off: 00 min”: the radio turns off in connection
with the ignition key; the radio is turned automatically
off as soon as the key is turned to the STOP position;
•
“Radio off: 20 min”: the radio turns off independently
from the ignition key; the radio remains on for a
maximum period of 20 minutes after the key has been
turned to the STOP position.
System Reset Function
This function is used to restore all settings to the factory
values. The options are:
•
NO: no restore intervention;
•
YES: the default parameters will be restored. During
such operation, the wording “Resetting” appears on
the display. At the end of the operation, the source
does not change and the previous situation will be
displayed.
14