Owner manual

The rear seat belts shall
be worn as shown in fig-
ure 6. Figure 6a shows
wrong seat belt fastening, not to
be followed.
11
GETTING TO KNOW YOUR CAR
fig. 7
P4Q00018
Remember that in the
case of violent collision,
back seat passengers not
wearing seat belts also represent
a serious danger to the front pas-
sengers.
ADJUSTING THE SEAT BELT
HEIGHT
There are two anchoring positions
A and B-fig. 7 for front seat belts on
the door post.
Before driving off for the first time,
adjust the position of the seat belt an-
choring point according to your height
and favourite driving position. If re-
quired, have the anchoring point of
the seat belt adjusted.
IMPORTANT Have this operation
performed at a Fiat Dealership only
as it involves passenger safety.
USING THE CENTRAL REAR
SEAT BELT
(For versions/markets)
To fasten the seat belt: push the
fastener tongue A-fig. 7a into slot B
of the buckle, until you hear it click.
To unfasten the seat belt: press
button C.
To adjust the belt: slide the web-
bing through D, pulling length E to
tighten and length F to loosen.
IMPORTANT The belt is adjusted
properly when it fits closely across the
hips.
fig. 7a
P4Q00037
In order to ensure that the correct
tabs are fitted into the corresponding
buckle, the tabs of the side belt and the
buckle of the centre seat (only ab-
dominal) are incompatible.