Technical Specifications

ManualsBrandsFIAT ManualsBathCascade 60 in. x 34 in. Single-Threshold Shower Floor in White

Customer Service Canada

1-800-387-0369

www.fiat.ca

Customer Service United States

1-800-442-1902

www.fiatproducts.com

FIAT

PRODUCTS

Revised 8/13

CASCADE

™

SHOWER FLOOR

WL / WLC / WLD SERIES

RECTANGLE, SQUARE OR CORNER

CASCADE

™

SHOWER FLOOR

SIERRA - FT / FTC SERIES

• Cascade shower  oor shall be the type as

manufactured by Fiat Products.

• Molding shall be done in matched metal dies,

resulting in a one piece homogenous product.

• A permanent slip resistant surface shall also be

integrally molded so that it will neither trap nor

impede the  ow of water.

• The shoulder shall be note less than 3 -1⁄16" high

or less than 1-1⁄2" wide. The tilting  ange shall

extend not less than 1-1⁄2" above the shoulder and

shall be not less than 1" higher than the threshold

providing an integrally molded water barrier. The

threshold shall be not less than 4-3⁄4" high (see

following table).

• Available in single and double threshhold and

neo-corner

• One-piece with 1-1⁄2" water retention tiling  ange

• Durable molded stone construction

• Slip resistant surface

• Integral molded drain with plastic strainer

• Each receptor comes with a protective coating

• Matching Estate™ shower wall surrounds, C9960/

U9960 (32"x 32"); C9970/U9970 (36"x 36"); C9980/

U9980 (48"x 36"); C9990/U9990

(36"x 36" right angle)

• Illustrated installation instructions included

• Available in White and Bone

IMPORTANT: Rough-in dimensions may vary 1/2" and are subject to

change or cancellation without prior notice.

SEE REVERSE FOR ROUGHING-IN DIMENSIONS

MODEL SIZE MODEL SIZE

32WL 32" x 32" 4832WL 48" x 32"

34WL 34" x 34" 54WL 54" x 34"

36WL 36" x 36" 60WL 60" x 34"

42WL 42" x 34" 34WLD 34" x 34" Double Threshold

4242WL 42" x 42" 36WLC 36" x 36" Neo-Corner

48WL 48" x 34" 36WLD 36" x 36" Double Threshold

38WLC 38" x 38" Neo-Corner

Summary of content (2 pages)

PAGE 1
FIAT CASCADE™ SHOWER FLOOR WL / WLC / WLD SERIES ® PRODUCTS RECTANGLE, SQUARE OR CORNER CASCADE™ SHOWER FLOOR SIERRA - FT / FTC SERIES • Cascade shower floor shall be the type as manufactured by Fiat Products. • Molding shall be done in matched metal dies, resulting in a one piece homogenous product. • A permanent slip resistant surface shall also be integrally molded so that it will neither trap nor impede the flow of water.
PAGE 2
FIAT CASCADE™ SHOWER FLOOR WL / WLC / WLD SERIES ® PRODUCTS RECTANGLE, SQUARE OR CORNER 2-3/4" MIN. (70mm) 1-9/16" (41mm) 1-1/2" C (38mm) WATER BARRIER A SECTION THRU THRESHOLD OF ALL MODELS SUPPLIED QIC NOTE: Quick Drain connector, QDC-2, is supplied with each floor, for use as a drain caulk to replace the lead caulk process (as desired).