Owner's manual

52
It allows to prolong the “open hood”
season.
FITTING THE WIND STOP
(1
st
fitting)
1) Fit the side brackets A and B
fig. 69 in the holes on the internal
sides of the car, on the right and on
the left.
2) Fasten the side brackets A and B
to the body with the nuts and screws
provided. Insert the screws and the
washers from the outside of the body
side and fasten the brackets from the
inside with the nuts, fig. 69.
3) Fit the ends of the wind spot C
and D fig. 70 inside the previously fit-
ted brackets. Make sure that the wind
stop cover is facing the rear part of the
car.
4) Position the cover E-fig. 71 on
the brackets A and B as shown in the
figure. Then fasten knobs F on the sup-
porting bracket screw.
5) Fasten the knobs F so to lock the
wind stop in position.
The wind stop will not prevent open-
ing and closing the hood once it is fit-
ted.
REMOVING THE WIND STOP
Simply loosen the fastening knobs F
by turning them anticlockwise. Re-
move the wind stop by pulling it up-
wards. After removing the wind stop,
refasten the knobs F on the support-
ing brackets.
For refitting the wind stop, simply
loosen the fastening knobs F, insert
the wind stop and fasten it. Leave sup-
porting brackets A and B fitted.
For safety reasons, do not
store the removed wind
stop in the passenger compart-
ment.
WARNING
fig. 71
P5S10025m
Fit and remove the wind
stop with the hood folded
away in the specific compartment
and the hood compartment open.
WARNING