Operation Manual

Restoring the stored
speed
If the device has been deactivated, for
example by depressing the brake or
clutch pedal, the stored speed can be
restored as follows:
❒ accelerate progressively until a speed
close to that stored is reached;
❒ engage the gear selected at the time
that the speed was stored;
❒ press button B fig. 150.
Increasing the stored
speed
This can be done in two ways:
❒ by pressing the accelerator and
memorizing the new speed reached;
or
❒ by moving the stalk upwards (+).
Each operation of the stalk will
correspond to a slight increase in
speed of about 1 km/h, while keeping
the stalk upwards will increase the
speed continuously.
Reducing the stored
speed
This can be done in two ways:
❒ by deactivating the device and then
storing the new speed
or
❒ by moving the stalk downwards (-)
until the new speed, which will
automatically remain memorised, is
reached.
Each movement of the stalk will
correspond to a slight reduction in
speed of about 1 km/h, while keeping
the stalk held downwards will decrease
the speed continuously.
Deactivating the device
The device can be switched off by the
driver in the following ways:
❒ by turning ring nut A to the OFF
position;
❒ if the engine is stopped (leaving the
stalk ring nut at ON), when the
ignition key is next turned to ON,
Cruise Control will be activated
automatically.
Deactivating the
function
The device can be switched off by the
driver in the following ways:
❒ by pressing the brake pedal when the
device is adjusting the speed:
❒ by pressing the clutch pedal when
the device is adjusting the speed;
❒ by pressing button B fig. 150 when
the device is adjusting the speed
(for versions/markets, where
provided);
❒ by pressing the accelerator pedal (in
this case the system is not actually
turned off but the acceleration
request takes priority; the cruise
control remains activated, without the
need to the press button B fig. 150
to restore the previous conditions
once the acceleration is over).
The device is automatically switched off
in the following cases:
❒ if the ABS or ESC systems intervene
❒ with the vehicle speed below the
set limit
❒ in the event of system failure.
142
STARTING AND DRIVING