Operation Manual

take wheel spanner B fig. 186 and
the extension with pentagonal fitting
C; inside the load area, fit extension
C on bolt A; use spanner B to lower
the wheel by unwinding the wire;
use the wheel dismantling spanner B
to remove the wheel from the vehicle
fig. 187;
unscrew knob D fig. 188 and release
the rim from bracket E, removing it
from the hole of the rim;
for versions with alloy rims, remove
the press-fitted hub cap;
loosen the fixing bolts of the wheel to
be replaced by about one turn, using
the spanner provided;
remove wedge D from the tool bag
and open it as shown in fig. 189;
place the wedge D behind the wheel
diagonally opposite the one you want
to replace fig. 190 to prevent the
vehicle from moving when it is raised.
operate the jack using the knob
(release the handle from the clip and
the hole on the nut) in order to open
it partially fig. 191, then position it
under the vehicle in line with
references A fig. 192 near the wheel
to be changed.
operate the jack with the knob to
open it until the groove A fig. 193
of the jack is correctly inserted in the
lower profile B on the side member:
B
C
186
F0V0150
187
F0V0151
188
F0V0193
189
F0V0192
190
F0V0153
167