Operation Manual

❒ warn anybody nearby that the vehicle
is about to be lifted. They must stay
clear and not touch the vehicle until it
is back on the ground.
❒ introduce the handle in the hole on
the nut and the plastic clip, then
operate the jack and raise the
vehicle, until the wheel is a few
centimetres off the ground. When
turning the crank, ensure that it
rotates freely in order to avoid grazing
your hands against the ground. The
moving components of the jack
(screws and joints) can also cause
injuries: avoid touching them. If
you become soiled with the
lubricating grease, clean it off
thoroughly;
❒ fully loosen the fixing bolts and
remove the wheel;
❒ make sure the contact surfaces
between spare wheel and hub are
clean so that the fastening bolts will
not come loose;
❒ fit the standard wheel by inserting the
first bolt B fig. 194 two threads into
the hole closest to the inflation valve
A;
❒ fit the hubcap, making sure that the
symbol
aligns with the inflation
valve, and then insert the other three
bolts.
❒ tighten the bolts using the spanner
provided;
❒ turn the jack handle to lower the
vehicle, and remove the jack;
❒ use the wrench provided to fully
tighten the bolts, passing alternately
from one bolt to the opposite one,
as per the numerical sequence
illustrated in fig. 195.
191
F0V0154
192
F0V0155
193
F0V0156
194
F0V0157
195
F0V0158
168
IN AN EMERGENCY