Operation Manual

At the end of the
operation
❒ fix bracket A fig. 196 to the wheel
after passing it through the hole,
insert the threaded pin into one of the
bolt holes and secure by tightening
knob B;
❒ for vehicles with alloy rims take the
adapter D fig. 197 and fit the plastic
spacer C between the spring and the
flange of the bracket. The plastic fin
must be directed downwards and
perfectly coincide with the flange cut
part;
❒ fit the bracket E fig. 198 in the
adapter D, fit the pin in the hole and
fasten by the knob F;
❒ position the wheel vertically and rest
the fitted adaptor on the inside of the
rim, then using the screws provided
fix the wheel to the adaptor, using the
socket wrench for the wheel nuts G
fig. 199. Tighten the screws with
the wheel removal wrench.
NOTE Use the spare wheel covering
bag to protect the replaced alloy wheel.
❒ Check that the position of the
replaced wheel under the platform is
correct (the lifting system is equipped
with a clutch to limit the end of the
stroke, incorrect positioning may
jeopardise safety;)
❒ put the jack and the tools back in the
dedicated tool bag;
❒ reposition the tool bag behind the left
side seat (Cargo versions) or, resting
the bottom of the bag against the
side panel, in the compartment inside
the rear right side (Doblò/Doblò
Combi versions).
196
F0V0194
197
F0V0214
198
F0V0215
G
199
F0V0216
169