Operation Manual
❒ after disconnecting the battery
charger, reconnect the quick-release
negative terminal A to the dummy
pole B.
Versions without dummy pole fig.
219
To recharge proceed as follows, paying
great care:
❒ press button A to detach connector
B from battery status monitoring
sensor C (this is located on the
negative pole of the battery itself);
❒ connect the positive cable (+) of the
battery charger to the battery positive
terminal (+);
❒ connect the negative cable (–) of the
battery charger to the pin D of the
negative battery terminal (–);
❒ turn on the charger;
❒ when you have finished, turn the
charger off before disconnecting
it from the battery;
❒ reconnect the connector B to the
sensor C of the battery.
136) 137)
WARNING
136) Battery fluid is poisonous and
corrosive: avoid contact with
your skin and eyes. The battery
recharging operation must be
performed in a ventilated place,
away from naked flames or
possible sources of sparks to
avoid the risk of explosion and
fire.
137) Don't try to recharge a frozen
battery: it must be thawed first,
otherwise it may explode. If the
battery was frozen, have it
inspected by specialised
personnel before recharging to
check that the internal elements
are not damaged and that the
casing is not cracked, which
causes the risk of leakage
of poisonous, corrosive acid.
WINDSCREEN/REAR
WINDOW WIPER
(for versions/markets, where provided)
BLADES
Periodically clean the rubber part using
special products; TUTELA
PROFESSIONAL SC 35 is
recommended.
Replace the blades if the rubber edge is
deformed or worn. In any case, it is
advisable to replace them
approximately once a year.
A few simple precautions can reduce
the possibility of damage to the blades:
❒ if the temperature falls below zero,
make sure that ice has not frozen
the rubber against the glass. Use a
de-icing product to release it if
required;
❒ remove any snow from the glass: in
addition to protecting the blades,
this prevents effort on the motor and
overheating;
❒ do not operate the windscreen and
rear window wipers on dry glass.
138)
219
F0V0380
202
SERVICING AND MAINTENANCE