Operation Manual

2. Finally, pull on any excess webbing to tighten the lap
portion around the child restraint. Any seat belt
system will loosen with time, so check the belt
occasionally, and pull it tight if necessary.
Installing a Child Restraint with an ALR:
1. To install a child restraint with ALR, first, pull
enough of the seat belt webbing from the retractor
to route it through the belt path of the child re-
straint. Slide the latch plate into the buckle until you
hear a “click.” Next, extract all the seat belt webbing
out of the retractor and then allow the belt to
retract into the retractor. As the belt retracts, you
will hear a ratcheting sound. This indicates the
safety belt is now in the Automatic Locking mode.
2. Finally, pull on any excess webbing to tighten the lap
portion around the child restraint. Any seat belt
system will loosen with time, so check the belt
occasionally, and pull it tight if necessary.
NOTE: When installing a child restraint, if it inter-
feres with the Head Restraint, recline the seatback
slightly to remove the interference.
To attach a child restraint tether strap:
• Route the tether strap to provide the most direct
path for the strap between the anchor and the child
seat, preferably between the head restraint posts un-
derneath the head restraint. For center seating posi-
tion, adjust the head restraint to the upward position
and route the tether strap between the head restraint
posts underneath the head restraint. Then, attach the
hook to the tether anchor located on the back of the
seat. (fig. 136)
• If necessary, move the seat forward to provide better
access to the tether anchor. (fig. 137)
• Attach the tether strap hook of the child restraint to
the tether anchor and remove slack in the tether strap
according to the child restraint manufacturer's instruc-
tions.
NOTE: Ensure that the tether strap does not slip into
the opening between the seatbacks as you remove
slack in the strap.
(fig. 136)
Tether Strap Mounting
180
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS
AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
CARE
TECHNICAL
SPECIFICATIONS
CONTENTS