Instruction Manual

Proceed as follows:
❒ Connect positive terminals (+) of the
two batteries with a jump lead;
❒ With a second lead, connect the nega-
tive terminal – of the auxiliary battery
to an earthing point E on the engine or
the gearbox of the car to be started;
❒ Start the engine;
❒ When the engine has been started, re-
move the leads reversing the order
above.
If after a few attempts the engine does not
start, do not insist but contact the near-
est Fiat Dealership.
IMPORTANT Do not directly connect the
negative terminals of the two batteries:
any sparks may ignite the detonating gas
which could come out of the battery. If the
auxiliary battery is installed on another
car, avoid metal parts touching acciden-
tally between this car and the one with the
flat battery.
JUMP STARTING fig. 1
If the battery is flat, it is possible to start
the engine using an auxiliary battery with
the same capacity or a little higher than
the flat one.
fig. 1
125
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
Never use a battery charger
to start the engine as this
could damage the electronic
systems of your car, particu-
larly the ignition and fuel supply con-
trol units.
The starting procedure must
be carried out by qualified
personnel because incorrect opera-
tions may cause electrical discharge of
considerable intensity. The liquid con-
tained in the battery is poisonous and
corrosive. Avoid contact with the skin
and eyes. Keep naked flames and light-
ed cigarettes away from the battery
and do not cause sparks.
WARNING