User Manual

200
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
ENGINE STARTING
EMERGENCY START-UP
If the Fiat CODE system fails to deactivate engine
immobilising system the warning lights
Y
and
U
stay on and the engine cannot be started.
To start the engine the emergency start-up can be
performed.
Read the whole procedure carefully before trying to
carry it out. If you make a mistake, you must turn the
ignition key back to STOP and repeat the whole
operation from beginning.
Proceed as follows:
Read the 5-figure electronic code given on the
CODE card;
Turn the ignition key to MAR;
Press and hold down the accelerator pedal. The
warning light
U
turns on for about 8 seconds, and
then goes off;
Release the accelerator pedal and get ready to
count the flashes of the
U
warning light;
Count the number of flashes that corresponds to
the first figure of the code on the CODE card, then
press the accelerator pedal and keep it there until
the
U
warning light comes on (for 4 seconds) and
then goes off; release the accelerator pedal;
The warning light
U
will start flashing again: after it
has flashed the number of times that corresponds
to the second figure on the CODE card, press the
accelerator pedal to the floor and keep it there;
Do the same for the remaining figures on the
CODE card;
Once the final figure has been entered, keep the
accelerator pedal pressed. The warning light
U
will light up for 4 seconds and then goes out.
Release the accelerator pedal;
Rapid flashing of the warning light
U
(for about 4
seconds) confirms the operation has been carried
out successfully;
Start the engine by turning the ignition key from
MAR to AVV.
If however the warning light
U
stays on, turn the
ignition key to STOP and repeat the procedure from
step one
IMPORTANT After an emergency start-up, you should
contact a Fiat Dealership otherwise you will have to
repeat the procedure described each time you want to
start the engine.