Installation Instructions

ManualsBrandsFiat ManualsPlumbingFIAT Floor-Mounted Single Compartment Laundry Tub

MODEL P-1

MODEL FL-7

MODEL SF-1F

MODEL SF-1W

MODEL LTD II

MODEL FLTD II

MODEL L1

MODEL FL1

TUFF TUB TO GO

ASSEMBLY INSTRUCTIONS

for LAUNDRY TUBS

W ALL AND LEG MOUNTED UNITS

BOTTOM

OF TUB

LEG MOUNTED PROCEDURE

The laundry tub may be leg or wall mounted. Models

with an “F” suffix (SF-1F for example), are leg mounted

tubs, and are shipped with four leg assemblies. Leg

mounting is the same for single or double tubs.

To mount legs on tub, turn unit upside down and lay

on protected surface.

DETAIL B

Slip noched end of leg into corner of tub as shown

in DETAIL A.

Drive the leg home by striking with a wood block and

hammer. Apply one leveling device on each leg as

shown in DETAIL B. NOTE: Certain leg assemblies

have a Tinnerman Clip on the leveling device, rather

than two nuts.

Adjust all four legs after standing tub upright.

Steel Leg

Leveling Device

Anchors

(Furnished by others)

W ALL MOUNTED PROCEDURE

Studding

Blocking

Lag

Screws

Bracket

Laundry tubs with an “W ” suffix in the model number are

wall mounted tubs. Instead of legs, these tubs are shipped

with filler panels that must be installed. Drill out plastic filler

panel hole on the back of the tub skirt and Insert the tab (A)

into the slot under the tub rim. Push the anchoring barb (B)

into the hole in the tub skirt. Repeat for opposite panel.

Each of the filler panels are marked L or R and should

be installed accordingly.

W hen mounting tub to a stud wall, install wood blocking to

bridge the studs. For double tubs, fasten the mounting

brackets to the wall 33-1/8” up from floor with 1/4” lag screws.

Make sure lag screws drive into studs or blocking.

Note:

Single tub units use a single hanger. Fasten wall mounting

hanger to the wall 33-1/8” up from the floor with three 1/4” lag

screws. Two screws be placed in the outermost holes

of the bracket to properly attach the tub to the wall.

Lift and place sink over wall mounting bracket(s). Make sure

tub is seated securely on the lip of the mounting bracket(s).

See DETAIL “C”.

SINGLE TUB

MOUNTING BRACKET

DETAIL C

33-1/8”

must

DETAIL A

Leg

W all

Floor

Summary of content (2 pages)

PAGE 1
R ASSEMBLY I NSTRUCTI ONS f orLAUNDRY TUBS W ALL AND LEG MOUNTED UNI TS MODEL P-1 MODEL FL-7 MODEL SF-1F MODEL SF-1W MODEL LTD I I MODEL FLTD I I MODEL L1 MODEL FL1 TUFF TUB TO GO LEG MOUNTED PROCEDURE St eelLeg Level i ng Devi ce Leg Anchors (Furni shed byot hers) BOTTOM OF TUB DETAI L A DETAI L B Sl i p noched end ofl eg i nt o corneroft ub as shown i n DETAI L A. The l aundry t ub may be l eg orwal lmount ed.
PAGE 2
TUFF TUB TO GO Fasten wall mounting bracket to concrete or cement block wall construction by following the same procedure for wood stud walls discussed earlier. DETAIL OF FAUCET, SUPPLY LINES WASTE LINES, AND TRIM ASSEMBLIES Drill holes with a masonry bit and use lead alloy screw anchors with 1/4” lag screws and flat washers. 1 A-1 Faucet Apply teflon tape to threads before supply connection.