Technical Specifications
FEATURES
NOTES
CR/PL© 03/03 Printed in U.S.A.
* Not furnished by Fiat Products. Description for specification purposes only.
OPTIONS
FIAT PRODUCTS
A CRANE PLUMBING COMP ANY
¤
T
UF-TUB
™
LAUNDRY TUBS
SF-1-F
SF-1-W
Single Compartment
Laundry Tubs
• SF-1-F / SF-1-W
The single compartment Tub-Tub™ laundry tubs
from Fiat Products, is manufactured from a
molded, fine celled, structural plastic polymer.
The basic model number is SF-1 and has an
integrally molded drain. Plastic stopper and tail
piece nut with washer are supplied with all
models. Water capacity is twenty (20) gallons.
Outside, front to back dimensions are equal to
laundry room appliances (washer and dryer).
Overall outside dimensions measured at the top
of the tub, are 20" x 23
7
/8" x 14
3
/8" and inside,
compartment dimensions, measured at the drain
opening, are 19
1
/4" x 19
1
/2" x 13".
A 4" ledge, integrally molded at back of the unit,
includes two (2) soap dish locations and two 1"
diameter molded holes. Holes are used to
accept an optional, 4" on centers deck faucet.
NOTE: Certain geographic locations require no
holes in the back ledge, and are molded
accordingly.
The floor mounted Tub-Tub™ model SF-1-F
shall be supported by factory furnished, white
baked enamel steel angle legs that fit into the
molded retainers located in each of four corners
of the underside of the laundry tub. The fully
assembled model shall withstand loads of up to
250 lbs. Legs are supplied with leveling
devices. Recommended height of installed unit,
from floor is 33
3
/4".
The wall hung Tuf-Tub™ model SF-1-W shall be
supported by a heavy guage, galvanized steel
mounting bracket capable of being secured to
the wall with mechanical fasteners and capable
of withstanding loads of up to 250 lbs. Side
fillers and bottom tub supports, made of white,
molded plastic polymer, are factory supplied and
assembled in the field in accordance with
installations instructions. Recommended height
of unit from floor is 33
3
/4".
• Also available in a six-pack carton, and as such,
respective packaged model designations become SF-6-F
(for floor mounted) and SF-6-W (for wall hung), and should
be ordered accordingly.
• Deck type faucet (4" centerset) with 6
3
/4" spout. (A-1)
• Polypropylene faucet block, 5
1
/8" x 1
1
/2" x 1
1
/4" for installing
clamp-on or integral clamp faucets to deck to accept over
head water supplies. (A-3)
• Overflow tube for SF-1. (A-15)