User's Manual

11
ADDING/REMOVING THE DEVICE
#5: Adding/removing the device
Adding (Inclusion) - Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
To add the device to the Z-Wave network:
1. Place the Dimmer 2 within the direct range of your Z-Wave
controller
2. Identify switch no. 1 (turns the light on) or the B-button (located
on the device’s housing)
3. Set the main controller in (security/non-security) add mode (see
the controller’s manual)
4. Quickly, three times press switch no. 1 or the B-button
5. Wait for the adding process to end
6. Successful adding will be conrmed by the Z-Wave controller’s
message
NOTE
In case of problems
related to unknown
conguration or type
of external switch use
the B-button to add/
remove.
i
CAUTION
While adding the
Dimmer 2 to the
network with
connected toggle
switch, ensure that
all switch contact is
open (o). Otherwise
it will prevent adding/
removing the device
to/from the network.
!
Removing (Exclusion) - Z-Wave device learning mode, allowing to
remove the device from existing Z-Wave network.
To remove the device from the Z-Wave network:
1. Place the Dimmer 2 within the direct range of your Z-Wave
controller
2. Identify switch no. 1 (turns the light on) or the B-button (located
on the device’s housing)
3. Set the main controller in remove mode (see the controller’s
manual)
4. Quickly, three times press switch no. 1 or the B-button
5. Wait for the removing process to end
6. Successful removing will be conrmed by the Z-Wave controller’s
message
7. Dimmer 2 will start the calibration process (see „Calibration” on
page 15)
NOTE
Removing the Dimmer 2
from the Z-Wave net-
work restores all the
default parameters of
the device, but does
not reset power me-
tering data.
i
NOTE
For toggle switches in
default conguration
perform six position
changes.
i
NOTE
Adding in security
mode must be per-
formed up to 2 meters
from the controller.
i
NOTE
Adding/removing is
not possible during the
calibration procedure.
i