User Manual

10
OPERATING THE DEVICE
#6: Operating the device
Acoustic and visual indications:
The Swipe is equipped with a buzzer and LED diode, signalling ges-
ture detection, menu position and status of the device.
Validity of every detected gesture or sequence is signalled by:
• 2 short beeps (GREEN) - gesture/sequence is valid
• Intermittent tone (GREEN) - smooth control using circular
gesture
• 1 long beep (RED) - gesture/sequence is invalid
Reset procedure of the Swipe:
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user conguration will be deleted. In order to reset the device:
1. Make sure the device is powered.
2. Choose 3rd menu position (3 short beeps).
3. After few seconds the device will be restarted. Not being added
to the Z-Wave network will be signalized with sequence of 2 short
beeps, pause, 1 short beep (RED).
Waking up the device:
The Swipe needs to be woken up to receive information about the
new conguration from the Z-Wave controller, like parameters and
associations. Use 1st menu position to wake up the device or click the
button on the back of the device once.
Menu allows to perform Z-Wave network actions. In order to use the
menu:
1. Move and hold your hand close to the center of the pad.
2. Loud sound sequence will conrm entering the menu, keep
holding your hand.
3. Wait for the buzzer to indicate the desired menu position:
• 1 short beep (WHITE indicator colour) - wake up the device
• 2 short beeps (GREEN indicator colour) - learning mode
(adding/removing)
• 3 short beeps (YELLOW indicator colour) - the device reset
4. To select current position, withdraw the hand and perform swiping
up gesture to conrm selection (two beeps will conrm validity).
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. Use
the reset procedure
only if the primary
controller is missing
or inoperable. Certain
device removal can be
achieved by the pro-
cedure of removing
described in "Adding
the device" on page
8.
i
NOTE
Gestures are not in-
dicated by the LED
diode by default. In
order to enable it, set
the value of parame-
ter 3 to 1.
i
NOTE
If the device is battery
powered, high pitch
beep will signalize ex-
iting from the Standby
Mode before entering
the menu.
i
NOTE
Menu can also be
operated using the
service button B (see
"Additional features"
on page 15)
i