User Manual

ASSOCIATIONS

25. SWITCH OFF control frame value for FLICK LEFT gesture

This parameter allows to set value sent in SWITCH OFF command

frame to the association group.

Available settings: 0-99 or 255

Default setting: 0 Parameter size: 2 [bytes]

26. SWITCH ON control frame value for FLICK RIGHT gesture

This parameter allows to set value sent in SWITCH ON command

frame to the association group.

Available settings: 0-99 or 255

Default setting: 255 Parameter size: 2 [bytes]

27. SWITCH OFF control frame value for FLICK RIGHT gesture

This parameter allows to set value sent in SWITCH OFF command

frame to the association group.

Available settings: 0-99 or 255

Default setting: 0 Parameter size: 2 [bytes]

SEQUENCES OF GESTURES

30. Sequence learning mode

Parameter activated by the main Z-Wave controller. Change its value to

launch sequence learning procedure for the desired slot.

Available settings: 0 - learning mode disabled

1-6 - launch sequence learning for selected slot

Default setting: 0 Parameter size: 1 [byte]

31. 1st gestures sequence (SLOT 1)

Value containing sequence of gestures. See "Sequences of gestures" on

page 12 for more information.

Available settings: 0-1076

Default setting: 0 Parameter size: 2 [bytes]

32. 2nd gestures sequence (SLOT 2)

Value containing sequence of gestures. See "Sequences of gestures" on

page 12 for more information.

Available settings: 0-1076

Default setting: 0 Parameter size: 2 [bytes]

NOTE

Sequences does not

allow to use same

gestures next to each

other.

NOTE

Parameters 31-36 can

also be used to manu-

ally set a sequence ac-

cording to details de-

scribed in "Sequences

of gestures" on page

12.