User Manual

ADDING THE DEVICE

#4: Adding the device

Adding (Inclusion) - Z-Wave device learning mode, allowing to add

the device to existing Z-Wave network.

To add the device to the Z-Wave network:

1. Place the Swipe within the direct range of your Z-Wave controller.

2. Set the main controller in (security/non-security) add mode (see

the controller’s manual).

3. Move and hold your hand close to the center of the pad.

4. If the device is battery powered, high pitched beep will signal

exiting the Standby Mode.

5. Loud sound sequence will conrm entering the menu, keep

holding your hand.

6. After hearing two short beeps (green indicator colour), withdraw

the hand and perform swiping up gesture to conrm selection

(two beeps will conrm validity).

7. Wait for the adding process to end.

8. Successful adding will be conrmed by the Z-Wave controller’s

message and 3 short beeps (green visual indicator colour).

NOTE

Adding in security

mode must be per-

formed up to 2 meters

from the controller.

NOTE

In case the device is

not added, please re-

set the device and re-

peat the adding pro-

cedure.