User's Manual

11
OPERATING THE DEVICE
Resetting the Door/Window Sensor:
Reset procedure deletes EEPROM’s memory, including all information
on the Z-Wave network and the main controller.
1. Open the cover.
2. Remove the battery.
3. Install the battery while holding both TMP buttons.
4. Release the TMP button within 5 seconds.
5. Visual indicator will blink 3 times to conrm launching of reset
procedure.
6. Wait around 30s for the resetting process to end, do not remove
the battery.
7. Visual LED indicator will blink 6 times to conrm the reset.
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. Use
reset procedure only
if the primary con-
troller is missing or
inoperable. Certain
device removal can be
achieved by the pro-
cedure of removing
described in “Adding/
removing the device”
on page 6.
i
Waking up the Door/Window Sensor:
The Door/Window Sensor needs to be woken up to receive informa-
tion about the new conguration from the controller, like parameters
and associations.
To wake up the sensor manually, click one of the TMP buttons (while
the other button is pressed).
Replacing the battery:
Life of the battery included with the device is from 12 to 24 months
(on default settings).
In FIBARO Home Center controller current battery level is displayed
in the interface. If a battery icon turns red, it means the battery needs
replacement.
NOTE
Opening the casing
may result in trigger-
ing an alarm. To avoid
it, remove the asso-
ciations for the 5th
group.
i
CAUTION
There is a risk of ex-
plosion if the battery
is replaced with an
incorrect type. Batter-
ies should be recycled
where possible. Dis-
pose of used batter-
ies according to the
environmental laws in
your country.
!